Product News

Product News

Analysis and repair of abnormal vibration of Roots blower

Roots blower vibration abnormal cause analysis

 

1. The device is unevenly installed

If the levelness and verticality of the equipment are not properly adjusted during the installation of the Roots blower, the equipment will vibrate during operation. In addition, if the Roots blower base is fixed unstable or the anchor bolt is loose, it will also cause abnormal vibration of the equipment.

2. The gear box is faulty

The gear box in the Roots blower is one of the key components. If the gear inside the gear box is seriously worn or the lubricating oil is insufficient, it will cause abnormal vibration. In addition, if the gearbox mounting fastening bolts are loose or the seals are aging and leaking, vibration problems can also be caused.

3. Bearing failure

The two rotors of the Roots blower are connected to the main shaft respectively through bearings. If the bearings are seriously worn or poorly lubricated, the vibration of the equipment will increase. In addition, improper bearing installation or obvious eccentricity between the shaft and the bearing is also one of the reasons for abnormal vibration.

4. The impeller is unbalance

The impeller is the key component of Roots blower, if the impeller design is unreasonable, manufacturing defects or the accumulation of pollution during use, it will lead to the imbalance of the impeller, and then cause the abnormal vibration of the equipment.

5. Drive motor problem

As the power source of Roots blower, if the motor itself fails or does not match with Roots blower, it will cause abnormal vibration of the equipment. At the same time, the unstable installation of the motor and the unstable power supply will also affect the vibration of the equipment.

 

Roots blower vibration abnormal repair measures

 

1. Check and adjust the device installation

First, adjust the levelness and verticality of the blower to ensure stable installation of the equipment. At the same time, tighten the bolts securing the base, and check whether the anchor bolts are tightened.

2. Check and maintain the gear box

Check the lubricating oil inside the gearbox regularly, and add or replace the lubricating oil as required. If the gear is found to be seriously worn, it should be replaced in time. In addition, check the gear box fastening bolts and seals to ensure that they are in good working condition.

3. Check and maintain bearings

Check the lubrication of bearings regularly, and add or replace grease as required. If the bearing is found to be seriously worn, it should be replaced in time. In addition, ensure that bearings are installed correctly to avoid obvious eccentricity problems.

4. Balance impeller

The impeller balance is tested regularly, and the impeller is adjusted or replaced according to the test results. In addition, pay attention to keep the impeller clean to avoid the accumulation of pollution.

5. Repair or replace the drive motor

If the drive motor itself is found to be faulty, it should be repaired or replaced in time. At the same time, ensure that the motor installation is stable, and check the stability of the power supply.

 

If you want to buy our products, please contact us at anytime.


Online Message

WhatsApp WhatsApp WhatsAppScan to follow Email Emailinfo@huadongblower.com Email Message Board
0.112631s